- This topic has 45 replies, 6 voices, and was last updated 3 years, 2 months ago by
.
-
Good evening.
Small update on my little project. I finally managed to prepare all the tin wear and paint it over last weekend (temperatures >15 deg.C). I replaced a few more gaskets (oil plug, fuel tap etc.), checked any for any leak and finally got it to run for 5 minutes. It runs well. Still need to finalise and install the pulley and the 2 supports on the shroud.
I’d like to use this engine to power a gen set: any recommendation for a gen set that would fit and where I could find a good second hand?
CheersAttachments:
- You must be logged in to reply to this topic.
