Pulley

This topic contains 6 replies, has 4 voices, and was last updated by  rotevat 2 months, 2 weeks ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #36656

    rotevat
    Participant

    Oh well my luck ran out in the end. I managed to break the crank belt pulley wheel on removal. It’s held in place by a grub screw and has (17) stamped on it. I dont suppose theses are still available ?

    #36657

    charlie
    Keymaster

    Might help if you say what engine/machine it is on. Photos are always helpful too.

    #36659

    wristpin
    Participant

    Is it on a green one by any chance?

    #36667

    rotevat
    Participant

    Fitted to cement mixer. 3 hp engine 1982 built date. Engine is black painted. Have someone Who has offered to weld it so fingers crossed.

    #36671

    charlie
    Keymaster

    If it cannot be welded two dimensions that will be needed to source a new pulley are diameter and belt cross section type.

    #36673

    ted20
    Participant

    why would a concrete mixer need a two speed pulley ? every one I have used is single for drum rotation speed unless the engine has been replaced from something else

    #36710

    rotevat
    Participant

    Not sure about two speed pulley. Standard P.T.O end one. Hopefully my attempts for a weld repair will be okay. Have not found a uk supplier of pulleys yet.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.